- L-port design diverter valve.
- 316 stainless steel available from stock.
- POM seats and Fluorocarbon (FKM) O-rings standard on stainless steel valves (-22DV).
- Handle shown in Handle Code field supplied standard.
Unit of Measure
Specifications
Brands |
N/A Anchor Fluid Power |
Nominal Size (DN) |
N/A 6 mm |
Connection Type |
N/A Society of Automotive Engineers (SAE) Thread |
Connection Size |
N/A 7/16 in. - 20 UNF-2B |
Handle Code |
N/A 32 |
Weight |
N/A 0.9 lb |
Maximum Pressure |
N/A 7250 psi |
Locking Kit Part Number |
N/A LK4/6 |
Port Type |
N/A "Diverter" L-Port |
Bore Restriction |
N/A Unrestricted Bore |
Body and Adapter Material |
N/A 316 Stainless Stee |
Ball and Stem Material |
N/A Duplex/316 Stainless Steel |
Adapter and Stem Seals Material |
N/A Buna Fluorocarbon (FKM) (Standard) |
Ball and Stem Seats Material |
N/A Polyoxymethylene (POM) |
Locking Kit |
N/A No Yes |
Number of Ways |
N/A 3 |
Dimensions
Dimension L |
N/A 2.72 in |
Dimension L2 |
N/A 1.42 in |
Dimension B |
N/A 1.18 in |
Dimension B1 |
N/A 1.36 in |
Dimension B2 |
N/A 1.83 in |
Dimension H |
N/A 1.18 in |
Dimension H1 |
N/A 0.59 in |
Dimension H2 |
N/A 1.28 in |
Dimension SW |
N/A 0.75 in |
Dimension SW1 |
N/A 0.28 in |
Ball Valve Pressure Specifications
Ball Valve Pressure Specifications |
N/A
Anchor Fluid Power ball valves are tested in accordance with ISO 12266-1 standards. End connections are manufactured in accordance with one or more of the following standards. SAE J1926-1 ISO 228-1 SAE J518-1 SAE J518-2 ISO 6162-1 ISO 6162-2 ANSI B.1.20.1 |
Note
Note |
N/A
Dimensions subject to change without notice. Only pressurize center port (port #2). Side ports (ports #1 and #3) should not be pressurized or be exposed to back pressure that is greater than the inlet pressure. Failure to follow these guidelines will result in internal leakage through the valve. For applications requiring pressure applied to side ports, please refer to AE3K Series valves. Please consult your system's seal manufacturer for recommendation of seal selection, as Anchor Fluid Power does not accept responsibility for seal selection. |
